Includes 4FL OZ Boeshield T-9 and 8.45FL OZ Boeshield Rust Free
Use Boeshield T-9 after cleaning with RustFree to protect stainless steel cable
Directions: For light rust on steel or cast iron, spray RustFree on a rag and wipe surface; Do not spray directly on surface, as it may cause spotting; For heavy rust, spray directly on rusted surface and scrub with Scotch-Brite pad; Wipe off and repeat if necessary; RustFree works best above 70¡ F
For maximum 1/8-in cable diameter
Used to protect cable from biting into wood
Used every instance where cable enters and exits a wood level pass through newel at an angle
Use with Linear Collection wood level pass through newels
Used to release the cable from the fitting if the cable lay is not smooth upon full insertion into the fitting the first time
A second attempt can then be made to install the cable end into the fitting
Level Blank Newel (3-1/3" square by 47-1/2") for Cable or Tube System.
This newel is not pre-drilled and can be made custom drilled at the job site and used in level applications.
Available in red oak or hard maple.
Due to the nature of wood, the tension on the cables will need periodic adjustment by using two 3/8" open wrenches as described in the installation instructions.
Application:
Rake Blank Newel
System:
Cable or Tube Rake System
Dimensions:
3-1/2-in x 47-1/2-in
Our unique Linear Collection wood newels are sized for simplified installation and you will find variations to satisfy most stairway applications and layouts.
KEY FEATURES:
Can be used with cable or tube system
This newel is not predrilled and can be custom drilled and trimmed to be used at any rake location
Each newel post includes a 3/4-in x 2-in wood dowel for attaching the handrail
Apply 3-4 coats of polyurethane finish for the best protection
Level Pass Through Newel (3-1/3" square by 34-3/8", 37-3/8" or 40-3/8") for use on the level runs either midway (or no greater than 42" spans) between Level Start/Stop, Corner or Down Newels on a Cable system. Available in red oak or hard maple. Each newel post comes with a 3/4" x 2" wood dowel for attaching the 684 wood handrail. Available for 36", 39" and 42" rail height systems. Please note the newel lengths on the are 34-3/8" on a 36" system, 37-3/8" on a 39" system and 40-3/8" on a 42" system. Due to the nature of wood, the tension...
Our unique Linear Collection wood newels are sized and predrilled for simplified installation and you will find variations to satisfy most stairway applications and layouts.
KEY FEATURES:
Use with cable system
Predrilled with 10 to 12 holes on two sides for simplified installation
Use at the corner of two level runs
Designed for stairways with 7-1/2-in rise and 10-in run (approx. 36.9°)
Each newel post includes a 3/4-in x 2-in wood dowel for attaching the handrail
Apply 3-4 coats of polyurethane finish for the best protection
Level Start/Stop Newel (3-1/3" square by 34-3/8", 37-3/8" or 40-3/8") for beginning or end of each level run on Cable System. Available in red oak or hard maple. Each newel post comes with a 3/4" x 2" wood dowel for attaching the 684 wood handrail. Available for 36", 39" and 42" rail height systems. Please note the newel lengths on the are 34-3/8" on a 36" system, 37-3/8" on a 39" system and 40-3/8" on a 42" system. Due to the nature of wood, the tension on the cables will need periodic adjustment by using two 3/8" open wrenches as...
50' of stainless steel cable
Marine grade stainless steel cable
We recommend using our Cable Release Tool C-RELEASE and Cable Cutter C-CUTTER during installation
The tension on the cables will need periodic adjustment by using two 3/8-in open end wrenches, as described in the installation instructions
Use C-CLEANER Stainless Steel Cleaner & Protectant to keep your cable clean and protected
Use with C-PROTECTOR to prevent cable from biting into wood newels
Swageless Cable Fittings eliminate the need for expensive equipment
Use with box or square nose treads to create a modern designed stairway
150' of stainless steel cable
Marine grade stainless steel cable
We recommend using our Cable Release Tool C-RELEASE and Cable Cutter C-CUTTER during installation
The tension on the cables will need periodic adjustment by using two 3/8-in open end wrenches, as described in the installation instructions
Use C-CLEANER Stainless Steel Cleaner & Protectant to keep your cable clean and protected
Use with C-PROTECTOR to prevent cable from biting into wood newels
Swageless Cable Fittings eliminate the need for expensive equipment
Use with box or square nose treads to create a modern designed stairway
500' spool of stainless steel cable
Marine grade stainless steel cable
We recommend using our Cable Release Tool C-RELEASE and Cable Cutter C-CUTTER during installation
The tension on the cables will need periodic adjustment by using two 3/8-in open end wrenches, as described in the installation instructions
Use C-CLEANER Stainless Steel Cleaner & Protectant to keep your cable clean and protected
Use with C-PROTECTOR to prevent cable from biting into wood newels
Swageless Cable Fittings eliminate the need for expensive equipment
Use with box or square nose treads to create a modern designed stairway