Colonial Series 3-1/2" Square Ball Top Newel.
This newel has a 3-1/2" ball, 13" landing block, a 23" turning length and a 13-1/4" bottom block.
Picture shows the standard 4017BT. Difference in 4018BT is the larger landing block.
Typically in stock in Red Oak.
This is made from 3" square x 59" stock.
This newel has a 10" tall top block and an "ball" top.
This is part of our Traditional Series.
Typically not in stock in poplar, red oak and maple and may require 3 business days for production time.
This is made from 3" square x 59" stock.
This newel has a 10" tall top block and an "mushroom" top.
This is part of our Traditional Series.
Typically not in stock in poplar, red oak and maple and may require 3 business days for production time.
Application:
Curb Wall Level Run, Elevated Level Run
System: Level Panel 39-in System
Width: 42"
Use Location:
Interior Use Only
Pre-assembled panel that allows for simplified installation
Low Sheen Black finish
Panels eliminate the need to glue, sand, or drill for baluster holes; no marking or cutting to fit necessary
Installation hardware included
1/2-in x 1-1/2-in rectangular tube construction with .065 wall thickness
Every rake and level panel is predrilled on the top rung and includes screws for attachment to handrail
Rake and level panel runs cannot exceed 15-ft without a spacer newel
This is made from 3-1/2" square x 56" stock.
This newel has a 6-1/2" face and a 17-1/2" turning length.
This is part of our Hampton Series.
May require 3 business days for production time.
This is made from 3-1/2" square x 48" stock.
Hampton Series 3-1/2" Square Ball Top Newel.
This is considered a landing newel with a 10" face with a 17-1/2" turning length.
This is made from 3-1/2" square x 56" stock.
This is part of our Hampton Series.
This is considered a landing newel with a 10" face with a 17-1/2" turning length.
May require 3 business days for production time.
This is made from 3-1/2" square x 56" stock.
This is considered a landing newel with a 13" face with a 17-1/2" turning length.
This is part of our Hampton Series.
May require 3 business days for production time.
This non-sag adhesive is a flexible and highly versatile rubber-based compound that exhibits exceptional adhesive contact and sealant qualities
It is perfect for vertical or overhead use such as drilled holes on the underside of handrail for iron baluster installation
The tack time is approximately 4 minutes with a full cure time of 24-72 hours, depending upon amount used, temperature and humidity
Use with a standard caulk gun cartridge
Fills approximately 110 holes depending on hole size
10.2 Oz Clear Adhesive; Dries clear