We will send you an email to reset your password.
- 25%
$ 99.99
$ 133.34
The Zipbolt Drill Guide is used to align and drill Zipbolt hardware connection holes
This tool makes the job of boring accurately into the end grain of rails and fittings much easier
Instructions included
- 25%
$ 2.06
$ 2.75
The Zipbolt Driver is used in place of an allen wrench to install Zipbolt connectors
- 24%
$ 24.53
$ 32.70
Zipbolt Hardware
Use to connect handrail to fitting or handrail to handrail
2 Pack
Includes red oak wood plugs and driver
- 25%
$ 27.11
$ 36.15
Zipbolt Hardware
Use to connect handrail to a post to post newel at the top end of the stair rake
2 Pack
Includes red oak wood plugs and driver
- 25%
$ 27.70
$ 36.94
Zipbolt Hardware
Use to connect level handrail to post to post newels
2 Pack
Includes red oak wood plugs and driver
$ 10.29
This kit is fully concealable. Use on finished floor surfaces, landings and starting steps.
See newel mounting instructions at: http://ljsmith.com/assets/files/pdf/3004.pdf
- 34%
$ 26.46
$ 40.70
This kit is fully concealable. Use on finished floor surfaces, stairs, ceramic tile and concrete. see user guide below: Installation Instructions for LJ-3005 Keylock™ Newel Post Fastener 1. Place the newel post in the desired location where adequate backing is available. Draw a line around the newel post base. Set the Keylock plate in center of the drawing and mark plate for inletting. 2. Inlet the plate 1/16" below the finished surface (stair tread, nosing, etc.) with a router or chisel. Chisel out the keyhole hole area 1/4" to 3/8" deeper, and wide enough for the lag bolt head to...
- 25%
From $ 10.59
$ 14.12
Use to mount 3" to 3 ½" newel posts on finished floor surfaces.
Includes: 1 - 3/16"x4 1/2"x4 1/2" Steel Mounting Plate, 12 - #9x2" Wood Screws, 4 Pieces of Wood Trim Moulding, Installation Instructions.
- 30%
$ 11.64
$ 16.63
Use to mount newel posts on finished floor surfaces. The 101-NF is 10-3/4" long - allowing for nearly 6" of lag. Kit comes with bolt, curved washer, 5/16" nut and 1-1/2" tapered plug.
See installatin instructions at: http://ljsmith.com/assets/files/pdf/3008-10.pdf
From $ 23.87
Use to mount newel posts on finished floor surfaces.
Includes: 4 - 16 ga. Metal Brackets, 32 Wood Screws, 4 Pieces Pre-mitered Wood Moulding, Installation Instructions.
See instructions at: http://ljsmith.com/assets/files/pdf/3009.pdf
